Thingiverse
QR1 lite Tool
door elknerps
8
Downloads
8
Likes
0
Makes
A tool to loosen QR1 connector. Stores on side of DD in mounting slots.
Print at 30% infill and you should be ok using this. Since the contact points are at an angle, you have just about the same amount of outward force as rotational and the PLA tool will break first. I would not put it to the test though, stop when you can't see the line.
Print at 30% infill and you should be ok using this. Since the contact points are at an angle, you have just about the same amount of outward force as rotational and the PLA tool will break first. I would not put it to the test though, stop when you can't see the line.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
