QSI 500 Series Cable Bracket

I created a bracket that screws onto my QSI 540ws astronomical camera. This bracket provides support for the USB-B and DC power plug to keep them from wiggling and losing connection. The bracket also provides a lock-down channel to provide strain-relieve on the cables.

The set-screw shown is a spare #10-32 thumbscrew I had lying around. I have also attached an STL for a printed version

The bracket attaches with the existing screws on the camera. I am using on a QSI-540ws but I expect any series 500 camera will have the same jack configuration.

Some adjustments to the design may be needed if your USB-B connector is fatter or thinner than mine. You might also want to remix to punch a hole to access the ST-4 port if you use that.

I printed mine in Raptor PLA on a Monoprice Mini.