Thingiverse
Tools
Go to Model
QST Express caliper battery mod
469
Downloads
531
Likes
1
Makes
Replace the LR1130 with a AAA battery for the QST express caliper I got from Aliexpress. the battery is fiction fit with the bend on the side of the battery compartment.
You will need: wires, tinfoil, some type of glue and a multimeter (make sure the positive and negative it's not making contact! Very important!)
Route wire in the hole to the channel on the side and along the bottom and to the other end and add foil for contact. Spacing is abit tight, so take your time with it.
The lock screw and the battery cover screws will be tighten at the same place after
PS: Hot glue is your best friend here, use a flathead to smear the glue will help alot
Other generic brand might work as long as the measurement matches:
Screw center is 2.4mm from the edges. The battery cover is ~17.3x12.8mm. The top edge of the battery cover to the top side is 5.5mm
2023/07/07 update: added a STEP file for remix
You will need: wires, tinfoil, some type of glue and a multimeter (make sure the positive and negative it's not making contact! Very important!)
Route wire in the hole to the channel on the side and along the bottom and to the other end and add foil for contact. Spacing is abit tight, so take your time with it.
The lock screw and the battery cover screws will be tighten at the same place after
PS: Hot glue is your best friend here, use a flathead to smear the glue will help alot
Other generic brand might work as long as the measurement matches:
Screw center is 2.4mm from the edges. The battery cover is ~17.3x12.8mm. The top edge of the battery cover to the top side is 5.5mm
2023/07/07 update: added a STEP file for remix
feletoch also publishes on
33 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
