Thingiverse
Quad/Drone Wall Mount
von eried
22
Downloads
23
Likes
1
Makes
The main design is based on the source, however there are few changes, specially:
* Thinner in general. More than 1.5 mm is overkill for drones that weight less than a kilo.
* Hole for a small nail/tack (I think only double sided tape is not safe enough vs a mechanical link)
* Thinner in general. More than 1.5 mm is overkill for drones that weight less than a kilo.
* Hole for a small nail/tack (I think only double sided tape is not safe enough vs a mechanical link)
eried veröffentlicht auch auf
130 zusätzliche Modelle auf 2 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
