Quad "Special Cigarette" Capsule

This design was inspired by the capsule made by Pixxelsnake. I edited his design to make it threaded instead of using an O-ring because I didn't have any, and then made a new design that holds four rather than just one.

I shrunk the dimensions for the holder to a "cigarette" that is 100mm long, 11mm at its thickest, and 6.5mm at its thinnest and overall compared to the original the package is 50% larger.

To secure the lid, I used an M3 screw with a side filed flat, and a nut. These were added to the print, mid print, to create a seamless design.

This does mean the lid has to be suspended up on supports with a single layer cylinder in the middle that gets cut away at the end, so that the screw can be put in mid print.

I have since added a version with flat sides to stop it rolling around, this is compatible with the original lid, but I may edit the lid in future also.

I am also putting silicone around the lip of the lid, to create a waterproof seal, however this isn't a m