Quadcopter Frame

This is a quadcopter frame that I designed on Solidworks after the original frame for the quad that I bought broke. using 4 wooden booms you can put the quad together with a friction fit (this was printed in abs so the friction fit might not be as good for pla but a little hot glue would fix this).
STL's include:
- the motor mounts
- landing gear
- above frame table for cameras and gps
- center frame that holds a 3s 2200mah turnigy lipo and all of the supporting electronics

what is needed:
- all of the motors and electronics for a quad (motors, esc's, reciever,battery, power distribution, flight controller)
- 4 wooden booms 1/2 inch by 1/2 inch then any length that you want.