Quadmula Siren F5 Split Prints

Camera Plates:
Designed based on the o3 camera plate for the Siren F5 Split. It should work on the Standard Siren F5 too but I can't test to be sure. Built for the Vista/Runcam (19mm) single screw center mounting and the Flywoo naked o3 camera (18mm).
Normal version - flat on the camera side for easier printing and what is typically used by most manufactures
Bubble version - a built-in 'bubble' spacer on the camera side

PS-2 Spacers:
Print spacers in hard filament for a similar outcome to using the OEM aluminum spacer but will print fine in TPU as well. You can certainly use the stock aluminum PS-2 spacer for either mount. But you get a similar vibration-dampening Quadmula intended by using the appropriate spacing for your camera plate.
PS-2 - standard spacer
PS-2 19mm - longer PS-2 spacer for cameras requiring 19mm spacing
PS-2 18mm - longer PS-2 spacer for cameras requiring 18mm spacing

Antenna mounts:
O3 Antenna mount for Quadmula Siren F5 Split. Rotated at 22.5 degrees to prin