Quail Feed Trough

This is a quail feed tray that I use on a DIY breeding cage. Its a nice tight fit at the joints and I just epoxied it together. There are 2 trough styles. I realized after printing that the cage side was too high so I made an alternate design. There might be a little sanding depending on your printers ability and the feed grate will need to be trimmed to size post printing. The assembly picture shows the different pieces and how they fit together. For a 36" wide cage you will need. I just added the cage I printed that goes with this feeder. Its a large form factor so Its not for everyone but may spur ideas nonetheless. https://www.thingiverse.com/thing:6192843

1 FT_Right_Mount
1 FT_LEft_Mount
2 FT_Center_Mount
2 End_Trough
1 Center_Trough
3 Feed_Grate