Thingiverse
Quanum FPV Goggle Modification
by AITRI
4
Downloads
0
Likes
0
Makes
I bought a set of these goggles from Hobbyking.com. They are great for the price and work perfectly, except there is no place to put a battery and it doesn't come with a switch, so i decided to modify it myself and upload the it for others to use.
My previous setup had a long lead trailing into my coat pocket connected to the battery with the video receiver stuck to the side of the goggles using double sided tape, not to mention all the messy wires hanging down.
If you are planning on printing this, remember to keep it as light as possible as it's going to be uncomfortable otherwise.
Items:
Goggles: Quanum DIY FPV Goggle Set with Monitor (KIT)
Video Receiver: 5.8G Wireless FPV RX RC305
Battery: Gens Ace 1000mah 3S 11.1v 25C
Switch: RL3-5 series round rocker switch
Male & Female XT60 connector
All feedback is appreciated.
My previous setup had a long lead trailing into my coat pocket connected to the battery with the video receiver stuck to the side of the goggles using double sided tape, not to mention all the messy wires hanging down.
If you are planning on printing this, remember to keep it as light as possible as it's going to be uncomfortable otherwise.
Items:
Goggles: Quanum DIY FPV Goggle Set with Monitor (KIT)
Video Receiver: 5.8G Wireless FPV RX RC305
Battery: Gens Ace 1000mah 3S 11.1v 25C
Switch: RL3-5 series round rocker switch
Male & Female XT60 connector
All feedback is appreciated.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
