Thingiverse
Quest 1 - Ping pong paddle
von sanlaki
125
Downloads
79
Likes
3
Makes
# UPDATED VERSION is up!
ETT Discord: https://discord.com/invite/forfunlabs
----
**Two ways to print:**
1. Single piece print - print however you like. This requires supports + post production processing and clean up.
2. Two piece print - easy to print, stronger, no post production work! The new snap design works without the use of any glue or screw. **Superglue is *recommended but not required.**
Make sure you use the correct grip/top combo!
Use a 3/4" (20mm) velcro to secure the controller.
Get the product here:
https://sanlaki.shop/products/ping-pong-paddle-for-oculus-quest-2-1
ETT Discord: https://discord.com/invite/forfunlabs
----
**Two ways to print:**
1. Single piece print - print however you like. This requires supports + post production processing and clean up.
2. Two piece print - easy to print, stronger, no post production work! The new snap design works without the use of any glue or screw. **Superglue is *recommended but not required.**
Make sure you use the correct grip/top combo!
Use a 3/4" (20mm) velcro to secure the controller.
Get the product here:
https://sanlaki.shop/products/ping-pong-paddle-for-oculus-quest-2-1
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
