Quest 3/pro gunstock

VR gunstock for quest pro controllers, works well enough for me. The mating surface with the small curved edges works really well, once the magnets are close enough it snaps on pretty much instantly. The attachpoint prints will likely need supports, the parts that screw in are sized to fit into the slots snugly, so only put supports on the sides above or below the screw holes, and best not to use supports on the inside surfaces otherwise they will not mate properly. The other parts should print upright without the need for supports. Requires 2 x bar magnets (60 x 13.5 x 5 mm, I use https://www.amazon.co.uk/dp/B07LF6XYXW?ref=ppx_yo2ov_dt_b_fed_asin_title though these need to be removed from the covers, I've added both of the makeshift jig parts I used to the files: ‘magnetremovaljigpx.stl’). as well as 4 x m3 screws and nuts. the nuts are press fit and require a lot of force to press fit into, (tends to make a crack in the end of the gunstock but doesn't seem to affect how it ha