Quick Adjust Half-Nut Vise (updated)

This is an updated version of my quick adjust vise and desk clamp with a few dimensional improvements and the addition of TPU friction pads for the desk clamping jaws and the bottom of the vise.Regular vises require a lot of screwing - in and out and in and out as as you go from small parts to big parts. This half-nut vise allows you to lift the screw up out of the nut, quickly slide the movable jaw to a new position, and then re-seat the screw in the nut and tighten as you would with a regular vise. The desk clamp clamps to the edge of your desk or table, and features a ball-and-socket joint for adjusting the angle of the vise. You can also lift the vise off of the dovetail connector above the ball-and-socket to use the vise stand-alone. Finally, I've added grooves in the jaws of the desk clamp where you can insert short lengths of TPU filament to create a higher friction gripping surfaces.PrintingAll part are printed in PLA in the orientations shown with 0.2mm layer height. No suppor