Quick release for retractable caster fitting D-Box system.

11/28/22 - I decided no further changes are needed, so it is no longer in WIP status.

Edit: 11/21/2022 Added CasterPlate112mm.dxf. The 112mm is the length that I'm using and I think it works well. You can use it in place of the CasterPlate.dxf which needs to be cut to length.

Edit: 11/19/2022 Renamed all the files to make more sense. They were not changed in any way.

The 2D DXF files can be sent to a place like SendCutSend.com to be laser cut.

I made mine from .250 inch 6061 Aluminum

The files with a 2X in front of them can be ordered in a lot of 10 ( you need 8 )
The other files can be ordered require 4 parts. At the time I had mine made the cost was about $233.

The CasterPlate requires beveling the 6x M6 holes on each plate so the bolt is below the surface so it doesn't rub.

IMPORTANT! The CasterPlate is a little long. The flat end currently needs to be cut to length to adjust for height. I haven't finalized the height. I'm on carpet. Less is needed for h