Quick XYZ Axis Calibration Test

Quick print for calibration of X-Axis, Y-Axis, and Z-Axis. Three models are included, two 60 mm and one 30 mm.Before using one of these prints you should first make sure your bed is trammed (leveled), your e-steps are calibrated, and your z-offset is adjusted to prevent elephant's foot.PrintingUse either 0.16 mm, 0.2 mm, or 0.3mm layer height.No supports.CalibrationInstructions for Marlin…After you have measured the X, Y, and Z values, you may need to recalibrate your printer. The following identifies one method.Connect your computer to your printer using the USB port. Then using a program such as pronterface or octoprint send the “M503” command which will return a mess of information. Look for the line that begins with “M92”. This will include a set of numbers representing the current step values prefixed by either, X, Y, Z, or E. Write down the numbers that you need to update.Then find the new values by using the following formula:lengthRequested / lengthMeasured * currentStepValueAs