Thingiverse
QuickCar MDS10 Switch Box
von GSEninja
0
Downloads
0
Likes
0
Makes
Bolt holes to connect box are 4mm in diameter and require a bolt at least 60mm but no more that 70mm.
Holes to mount switch are 2mm in diameter, i threaded screws into the plastic to mount mine.
Wire holes are 14.5mm in diameter and rounded to prevent damage to the wire/insulation so that a grommet is not necessary. Holes are recessed at 19mm for the outer lip of the grommet.
Holes to mount switch are 2mm in diameter, i threaded screws into the plastic to mount mine.
Wire holes are 14.5mm in diameter and rounded to prevent damage to the wire/insulation so that a grommet is not necessary. Holes are recessed at 19mm for the outer lip of the grommet.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!