Quip Gum Insert for Eclipse Style Gum

I really liked the Quip Gum dispenser but was not a big fan of the gum itself. This insert allows you to load pieces of nine Eclipse gum in the dispenser (It can fit ten but works more reliably with nine results may vary though). There are no extra parts required, you only need the spring from the original insert and a scrap piece of filament.

To assemble the follower place the spring into it with the flat end of the spring pointing down. Then insert a piece of filament through the wholes in the follower and trim it flush. The flat end of the spring goes through the slot at the top of the insert, I use a piece of tape to make sure it will not slip out.

This project is far from perfect but it's working well enough. Would love to have a design the used the original follower, I just couldn't make it work hopefully someone else can.