Qx70 Motor / Prop Riser

The stock QX70 prop sits too low in the duct. I designed a very simple part that will help lift the motors so the props have enough clearance. It's a little more elegant than using hot glue and certainly looks better.

There are two versions. The original raises it up by about 2-3mm. The "tall" raises it up an additional 3mm. You may want to experiment to see which ones work best for you.

Printing Instructions:
I used .20 layer height
You will need a nozzle that is .40 or smaller to print this, as the walls are very thin. If your slicer struggles with printing the full model, check your nozzle settings. You may be able to adjust the nozzle size manually to .40 or less.

You should be able to use just about any filament for this. I'd recommend ABS or a flexible filament so it holds up better in crashes, but even PLA should work.

These don't even register on my digital scale. When printing with PLA, my slicer tells me the plastic weight is .38 grams.

Installing Instructi