R/C hovercraft

R/C hovercraft with parts that can be printed easily, and mostly without supports. The hovercraft will require some basic assembly work. Below, you'll find the list of parts required, as well as some assembly instructions and some explanations on how I created the skirt from a plastic bag.Short video: Parts required (Bill of Material):Electronics:Any radio system with 3+ channel R/C receiverOne channel for the hover fan (on a rotary knob, 3 position switch or slider)One channel for the propulsion fan (throttle channel)One channel for the rudder servo (steering or aileron channel)Two 1106 (4200 kV) brushless motors + screws (1104 and even lower kV should also work)Two 3016 propellers (GemFan)Two 10A brushless ESC (I used super cheap (obsolete but good enough) SimonK ESC's)One 9g servoOne XT30 (male) connectorOne small 2S or 3S Lipo (400-500mAh will do the job) with XT30 connectorOther (mostly junk you probably already have):Some heat shrink or (electical) tapeSome self-adhesive