Thingiverse
R2-D2 middle leg
por OldCrankyBmullz
25
Descargas
24
Likes
0
Makes
Print with cylinder side down for best fit into the figure's bottom hole.
My figure is a telescoping ESB R2-D2 and the hole tapers from 13.85-12.5 mm, so I used a 13.25 diameter and it seems to fit well. YMMV.
I used a 5mm brim for better stability as the base is pretty small.
Supports >60 deg recommended
50 mm/s speed
0.2 layer height gives pretty good detail.
My figure is a telescoping ESB R2-D2 and the hole tapers from 13.85-12.5 mm, so I used a 13.25 diameter and it seems to fit well. YMMV.
I used a 5mm brim for better stability as the base is pretty small.
Supports >60 deg recommended
50 mm/s speed
0.2 layer height gives pretty good detail.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
