Thingiverse
R2D2 Night Light
von CDRSpock
90
Downloads
74
Likes
0
Makes
Found this picture of R2D2 using a external light, So I tried to copy it as close as I can, ( the 3D program I have is not very good, and I'm still learning it)
The Center piece should be printer in clear or Transparent Yellow (If there is a Trasparent Yellow) I will be using LED for low power usage and tap in R2D2 for the power as pictured.
Place the two Support pieces in place after the LED's and Light are in place. (You will have to drill a hole for the power cord to size depending on the wire cable you use).
I hope you like it and if some one can do a remix for a better build matching the picture.
The Center piece should be printer in clear or Transparent Yellow (If there is a Trasparent Yellow) I will be using LED for low power usage and tap in R2D2 for the power as pictured.
Place the two Support pieces in place after the LED's and Light are in place. (You will have to drill a hole for the power cord to size depending on the wire cable you use).
I hope you like it and if some one can do a remix for a better build matching the picture.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
