R2D2 Pen Holder

I printed out sjpiper145's R2D2 pen holder, but found it was more to the size of golf pencils than pens. For my remix, I increased the size of everything 200%, adjusted the center leg attachment point, and added holes for putting in nails to act as joints. The holes are 1.5mm in diameter, which seemed to work well with the wire nails I had on hand.

I've found that supports are helpful for everything but the center foot, which has no overhangs. Also, the body was nearly impossible to seperate from the bed, but I stuck it in the freezer for a few minutes and it popped right off. After printing, every part can be assembled with the wire nails (I have no idea what size these nails are, so if you can figure it out from the picture, let me know in the comments), with the center leg attached to the body via some superglue.

Original design: https://www.thingiverse.com/thing:766574

Tinkercad models:
Body: https://www.tinkercad.com/things/5YsGahgfc2H
Everything else: https://www.tink