R8 Collet tool holder

My first R8 Collet holder. It holds 24 R8 collets, as well as its primary function was to be able to hold bits in the collet itself. There are tapered posts in each holder that if you always use lets say a 1/8" drill bit in the 1/8" R8 collet all the time it normally would just fall through. So this stops tools from falling out the bottom. Just was a matter of convenience for me that I didn't see any place else. The posts can be broken off if your tool doesn't allow them (like my drill chuck). I used a 30% infill with a honeycomb pattern and the number of walls was 4. I made it out of PETG with trees that used PLA as the mating surface and they came out very easily. Took around 24 hours to print with the flat base on the bottom.