R8 Collet Tray - Angled

This is an R8 collet tray. The top/bottom printed separately and press fit. Both parts are printable without supports. The top tray is reinforced and handles 23 R8 collets without sagging when printed in PETG with 3 loops. The holes fit R8 collets precisely, keeping them snug in place. There is enough clearance between the collets to allow for ease of grabbing. The entire setup is angled. Currently 45 degrees, but I'm happy to upload other angles if you'd like to comment what you need. I'm likely going to make a gridfinity bottom on the base for v2.