Thingiverse
R8 milling tool holder
von inspiredcricket
5
Downloads
2
Likes
0
Makes
Got an R8 problem ? Here is another solution. The holder will fit up to 6 tools. Some tools can be quite large in diameter, this will accommodate tools up to 40mm in diameter if placed side to side. To be printed vertically and without supports.
V2 will accommodate tools up to 50mm in diameter. Will need at least 290mm of Z travel to print that.
V3 is specifically for collets, with least amount of spacing.
10% fill is sufficient.
V2 will accommodate tools up to 50mm in diameter. Will need at least 290mm of Z travel to print that.
V3 is specifically for collets, with least amount of spacing.
10% fill is sufficient.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!