Thingiverse
Rabbit Ear Antenna for TinyGS
par Cathprotech
6
Téléchargements
12
Likes
0
Makes
This is used to hold the two wire elements of a Rabbit Ear antenna into the correct position and also hold an SMA connector.
It's not water proof but a little bit of silicone or grease inside should stop water running down the elements and into the connector.
Each element is about 165mm long and just some copper house wire, I think 2.5mm2 but anything will do.
It has come to my attention that the later version of Cura cannot separate the two halves to lay them flat on the build-plate for printing so I have re-uploaded the two halves as separate files.
It's not water proof but a little bit of silicone or grease inside should stop water running down the elements and into the connector.
Each element is about 165mm long and just some copper house wire, I think 2.5mm2 but anything will do.
It has come to my attention that the later version of Cura cannot separate the two halves to lay them flat on the build-plate for printing so I have re-uploaded the two halves as separate files.
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !