Racebox Micro Enclosure

Racebox Micro Enclosure with 4-AAA battery holder with switch. This will package your Racebox micro into an easy to setup/install device. Just print the two halves, pressure fit the original Racebox Micro polycarbonate enclosure and install the battery holder under it. Connect the wires and you are good to go. It will turn the module into a ready to use device using standard batteries. At 20mAH current usage, the batteries should last over 40hours easily.
Needs small screws : size M4 12MM x 4
Battery enclosure : https://www.amazon.com/dp/B0BBKRD7Y1?ref=ppx_yo2ov_dt_b_fed_asin_title
Printed with standard settings on my AD5x Printer with supports.