Thingiverse
Rack Legs for Nimble
door ZachAllen11
19
Downloads
14
Likes
0
Makes
\*\*Full build of the Nimble rack w/ BOM will be uploaded later.\*\*
Maximum length enclosure legs from the 6" Rack Enclosure that will fit within the Pelican 1430 Toploader case used in the Nimble while still allowing room for cables.
These are 280mm in length, which translates to 20U at 14mm/unit level.
If printing with an Ender 3 Pro, as I did, you will need to print them flat and at a 45 degree angle on the build surface to fit them within the build volume.
They don't need supports, but the bottom side will be imperfect. I chose to accept this compromise over fiddling with a large number of small, difficult to remove supports.
Maximum length enclosure legs from the 6" Rack Enclosure that will fit within the Pelican 1430 Toploader case used in the Nimble while still allowing room for cables.
These are 280mm in length, which translates to 20U at 14mm/unit level.
If printing with an Ender 3 Pro, as I did, you will need to print them flat and at a 45 degree angle on the build surface to fit them within the build volume.
They don't need supports, but the bottom side will be imperfect. I chose to accept this compromise over fiddling with a large number of small, difficult to remove supports.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
