RackPi Raspberry Pi Accessories

2U rack mount for RackPi inserts. Will accommodate up to 10. Also made a few blanks to fill in spaces not being used or taken up by something else.

05/13/2020 -- updated sides and middle bar modifying the 'nut' cylinders to attach to the top and bottom horizontal sections to add strength and hopefully prevent any detachment of the cylinders while attaching screws to the mount.

To print the rack mount:

For larger format printers:

2 x Large Side Brackets
2 x Connectors

For smaller format printers

2 x Small Side Brackets
2 x Small Center Bars
4 x Connectors

Screw holes are sized for m3 screws. In the US, #4 or #6 sheet metal screws should work fine.

The holes on the RackPi mounts appear to be around 4.5mm so this gives you the ability to shift the mounts slightly as needed to fit all 10 bays neatly. The m3 screws I used completely covered the RackPi mount holes.

If you want to leave a tip for this design, please direct it to the original RackPi designer.