Thingiverse
Radar Bucket
von RKilo
1
Downloads
1
Likes
0
Makes
Here is a 3D print of the 'radar bucket' to fit a Kustom Signals Falcon (or similar style hand held radar)
The first image is a real one, the one in the car is this 3D printed replica mounted.
The real ones were vacuum formed and then trimmed/cut with snips to fit any car/console, and holes were hand drilled wherever they were needed.
I've included two stl's, one like the real thing and one pre trimmed/drilled.
They usually get screwed to the side of the console or transmission tunnel.
Ive also included a template to print so you can cut a piece of rubber (or print it out of TPU) that sits inside to prevent scratching the lens.
If you are going to print the original one and trim it yourself, id recommend 100% infill.
I printed it out of ABS-GF for strength/heat resistance. No supports required if you are going to cover the inside with the rubber/TPU.
The first image is a real one, the one in the car is this 3D printed replica mounted.
The real ones were vacuum formed and then trimmed/cut with snips to fit any car/console, and holes were hand drilled wherever they were needed.
I've included two stl's, one like the real thing and one pre trimmed/drilled.
They usually get screwed to the side of the console or transmission tunnel.
Ive also included a template to print so you can cut a piece of rubber (or print it out of TPU) that sits inside to prevent scratching the lens.
If you are going to print the original one and trim it yourself, id recommend 100% infill.
I printed it out of ABS-GF for strength/heat resistance. No supports required if you are going to cover the inside with the rubber/TPU.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
