Radar Presence Sensor case with tilt mount

This Radar Presence Sensor is easy to build and pretty cheap considering its performance. The firmware uses ESPHome. The sensor uses the universal ball-joint design so it can be oriented for accurate detection. I provide a skadis mount which uses T-Nuts, but you can remix the base from the original design to fit your needs. Most LD2410 (C) modules sold have a convenient pinout that matches the right row of D1 Mini. This means you can simply solder the module directly to the board as a sandwich. No wiring needed. I would recommend putting some double sided tape to keep it stable, and this helps with soldering.Pinout:LD2410— D1 Mini VCC — VCC GND — GND OUT — IO16 RX — IO17 TX — IO21 Firmware: Follow ESPHome guide linked above for a starter firmware. I have a slightly modified version on my GitHub. The ESP is pressure fit to the bottom case as shown below.