Thingiverse
RADDS case for D-BOT
von printerboon
12
Downloads
6
Likes
0
Makes
I created an enclosure for my RADDS 1.5 board. It's _not_ snug fit, there is enough space to insert (and remove) the electronics without any force. Use four M3 screws and nuts to mount the electronics and two M5 screws to mount the enclosure to some 2020 profile.
Mount holes are located at the short side, so USB-connectors and SD-card slot will be face to the front.
The cover can hold two 40mm fans.
update: added a cover for a single 60mm fan. my (cheap) 40mm fans died, now I'm using a 60mm Sunon fan.
Mount holes are located at the short side, so USB-connectors and SD-card slot will be face to the front.
The cover can hold two 40mm fans.
update: added a cover for a single 60mm fan. my (cheap) 40mm fans died, now I'm using a 60mm Sunon fan.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
