Thingiverse
Radds HALL-E-Endstop holder
von freakezoid
3
Downloads
1
Likes
0
Makes
This is a simple holder for the RADDS Hall-E-Endstop on a 8mm rod.
The visible endstop is from the following repository
https://www.thingiverse.com/thing:697173
i cut direct M3 threads into the ABS. For the electronic i used plastic screws.
The visible endstop is from the following repository
https://www.thingiverse.com/thing:697173
i cut direct M3 threads into the ABS. For the electronic i used plastic screws.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!