Thingiverse

Radial Generator II

von Robotobi

483 Downloads

406 Likes

1 Makes

This thing is still a Work in Progress

A small radial generator

Designed for my wind turbine
http://www.thingiverse.com/thing:1718731

This version has three phases with serpentine winding.
I used 10x10x40mm Magnets in a Halbach array arrangement.

First measurements (after the rectifier) 8 windings (0,8mm wire) on one Phase at 400rpm with a 500mA load: 5V
I had only wire for 8 windings :-) and my wind turbine does not rotate with 400 rpm.
...there are still more tests needed...

#####___
#####update

#####15/09/2016:
Update Parts: „Stator_1x.stl“ and „Deckel_1x.stl“
easier to print but fully compatible with old version

#####___

#####**What you need**
32x..............Magnets 10x10x40mm (Q-40-10-10-N Supermagnete.de, Supermagnete.ch)
1x................M8 screw or threaded rod
3x................M8 Nut
2x................608 bearing Ø22xØ8x7mm (e.g. inline skates bearings)
4-8x.............M5 screw an Nut
8x..........

alternator CatchTheWind diy electric electrical free energy generator generators Halbach Halbach array neodym neodymium permanent magnets PM Generator serpentine vertical wind turbine wind wind energie wind energy alternator CatchTheWind diy electric electrical free energy generator generators Halbach Halbach array neodym neodymium permanent magnets PM Generator serpentine vertical wind turbine wind wind energie wind energy alternator CatchTheWind diy electric electrical free energy generator generators Halbach Halbach array neodym neodymium permanent magnets PM Generator serpentine vertical wind turbine wind wind energie wind energy

Quelle

Thingiverse

Was du zum Drucken brauchst: Mittel Niedrige Konfidenz

Einteilig Hardware nötig

Supports 1/3

Zusammenbau 0/3

Einstellungen 1/3

Druckbett 0/3

Nachbearbeitung 1/3

Drucker

FDM / FFF

Dateiformat