Radig Avr Node ArtNetNode enclosure

Inspired by [this slim enclosure for the "Radig DMX Ethernet Box"](https://www.thingiverse.com/thing:6232358), I created a similar enclosure for the slightly bigger Radig AVR Node. It turned out to be quite a tight fit, but once the board is in, it works nicely. I used three M3 threaded inserts to attach the lid and the XLR socket to the enclosure at the same time. For power I added a 10.5 mm hole where I glued a (round) connector in; you might have to adjust to your own needs. The board itself doesn't need any more screws to be held in place. The two little holes align with the onboard LEDs, which are visible when looking at the right angle (I didn't want to re-solder the LEDs).

I printed this without supports and with "fuzzy skin" because I like the aesthetics. Make sure your first layer is well tuned - otherwise the lid (with the XLR connector) won't fit well into the top opening!