Thingiverse
Radiomaster Boxer Kickstand
von bobgengeskahn
9
Downloads
9
Likes
0
Makes
Friction fit and stops at 45. PETG, no supports required. Requires replacing the handle screws with M3x12 to fit the kickstand and factory handle.
The square on the bottom was intended for velcro to hold the kickstand in, but the fit is tight enough off the printer its not needed. Maybe after it breaks in you will need velcro to keep it from flopping around.
The square on the bottom was intended for velcro to hold the kickstand in, but the fit is tight enough off the printer its not needed. Maybe after it breaks in you will need velcro to keep it from flopping around.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
