Radius Gauge Holder for Multiboard + Multiconnect

OverviewA multiboard holder for the radius gauge set, using slide-on multiconnect directional snaps on the back. Note that this model is designed specifically for the radius gauge sets listed below. Credits:Radius Gauge Sets: https://makerworld.com/en/models/1459301-radius-gauge-1-10mm-and-11-20mm-0-5mm-incrementsMultiboard: https://www.multiboard.io/Multiconnect (v2): https://www.printables.com/model/1074671-raised-multiconnect-generic-connector-for-multiboaInstructionsThe print will need minimal supports for the back side, so remember to turn that on. Images and print are based off Bambu X1C, printed at 0.4 mm nozzle size, with 0.2mm layer height. To attach the holder to your multiboard, you'll need to print four (4) of the Directional Snap pieces (see multiconnect link above). They are found in the .zip file you download from printables. Install the snaps in a two by two pattern with the arrow pointing up. Slide the gauge holder over the grid of snaps. Note: There is some tolera