RAGE! Foam Dart Blaster

This is RAGE! A Foam blaster designed for short dart (Talon) systems. The key feature of this design is the fact that it uses a smaller solenoid than most other solenoid builds. The Solenoid I designed this around is about half the size of the 35mm ones that are currently popular, but it functions exactly as needed (at only 15mm stroke). You can get the hardware directly from my etsy:

https://www.etsy.com/shop/RadBlasters/

Other than that feature, this is basically a primary blaster designed with competitive Nerf in mind. Fully built, this can get 150-160 FPS on 2x Fang Revamped motors with Inferno Wheels...and it can be select fire too!

. Here is a guide for every part and how I currently print them:

Front Receiver - I print it as it sits on the blaster. I add enough support to ensure i can get good bridging underneath. It can print upside down too. The less support the better as this is a very visible piece. Print at your desired resolution with 4 perimeters and at least