Railcore bed pivot offset laser calibration aid

Warning: This project, as designed, calls for a 650nm 5mw laser. NEVER POINT A
LASER AT ANYONES EYES, INCLUDING YOUR OWN, EVER! That means using proper safety equipment and being aware of reflective surfaces.

BE SMART. BE AWARE. BE SAFE!!! Even low power lasers can cause retinal damage.

***BUILD THIS AT YOUR OWN RISK!***


Tony Akens was kind enough to make a [video](https://www.youtube.com/watch?v=qeFGLb8Gf6U) on how to properly acquire calibration distances between each of the bed pivot points and the nozzle. While I found the video super helpful, I got frustrated trying to work my hands and eyes around the print head to take measurements and make markings.


Note:
I am NOT including assembly instructions for this project. If you cannot figure it out from
the photo and parts list, you probably should not be building this. This project requires
knowledge of how to use all tools and parts necessary for completion in a safe manner.


Caveats:
Designed for use with