Thingiverse
Railcore bottom brace drill template
by lostapathy
8
Downloads
2
Likes
0
Makes
This template is used to drill the holes in the railcore bottom panel to space the extra base extrusions in from the sides.
It will yield a 40mm spacing between the outside extrusion and the added extrusions. Place it all the way into the corner for the two outside end holes, and then measure the other 3 holes at approximately 90mm intervals.
It will yield a 40mm spacing between the outside extrusion and the added extrusions. Place it all the way into the corner for the two outside end holes, and then measure the other 3 holes at approximately 90mm intervals.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!