Thingiverse
Railcore Electronics Box Corner (Easy Mode!)
door milstrata
3
Downloads
1
Likes
0
Makes
This is an alternate electronics box corner for a Railcore 300 ZL/ZLT. This version has a place for a captive nut for each screw, and is designed to print without supports. There are also slight modifications so that all screws can be M3 x 10mm.
I've called it "easy mode" because it should make assembling the electronics box a lot simpler. (or it did for me, anyway!)
The deeper holes for captive nuts may require a longer screw to pull them tight. (this should be familiar if you've ever assembled an official Prusa printer) Once all nuts are in place, the M3 x 10mm screws should be able to reach all nuts.
I've called it "easy mode" because it should make assembling the electronics box a lot simpler. (or it did for me, anyway!)
The deeper holes for captive nuts may require a longer screw to pull them tight. (this should be familiar if you've ever assembled an official Prusa printer) Once all nuts are in place, the M3 x 10mm screws should be able to reach all nuts.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
