Railcore II Frame Mount Spool Holder

10/24/2018: Edited spool holder to have thinner post - the extreme bulge section didn't help. File is spool-holder-thin

Note: jstevewhite [remixed this one again to a design I'm happier with](https://www.thingiverse.com/thing:3024088) - it requires some 1/4th inch rod and some threaded inserts but it's way less material!

This is a remix of jstevewhite's frame-mount spool holder arms - I got tired of knocking off one arm when I was removing the spool, and I wondered if you could get away with only one arm.

I don't use a filament guide - you might want to. The original file has a filament guide that works quite well.

This is a longish print due to the size, but you can probably drop the infill down quite a bit - I did 20% and it took about 7 hours.

This fits on the Railcore 2, over the frame and one 1515 rail.

The photos are of "version 1", which is identical except for the cross bar - however it's too easy to tip it over, thus the increased support in version 2.

Not