Thingiverse
RailCore SlipFit Electronics Box
by veng1
11
Downloads
3
Likes
0
Makes
When I decided to reprint the RailCore Electronic Box corners in a different color, I figured in true RailCore spirit, I'd just redesign everything.
The corners do not require screws to hold in the sides as they just slide in and include a loft to support the top so no supports are needed.
There is a middle connector to fit the existing holes in the kit ZLT. It is not required for the ZL.
To allow access to the USB and SD card, there is a slot in the top front side.
The top rear side is modified to fit the power input that comes with the kit.
The bottom front, only for the ZLT, has a Decora on/off switch to make it easier to reach than the one in the back.
The bottom rear, only for the ZLT, has a convenience outlet to plug extra things into.
The corners do not require screws to hold in the sides as they just slide in and include a loft to support the top so no supports are needed.
There is a middle connector to fit the existing holes in the kit ZLT. It is not required for the ZL.
To allow access to the USB and SD card, there is a slot in the top front side.
The top rear side is modified to fit the power input that comes with the kit.
The bottom front, only for the ZLT, has a Decora on/off switch to make it easier to reach than the one in the back.
The bottom rear, only for the ZLT, has a convenience outlet to plug extra things into.
veng1 also publishes on
25 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!