RainBird 3500 nozzles

These are models for the RainBird 3500 rotor irrigation's nozzles.Unfortunately RainBird does not sell the nozzles for this specific model on a standalone basis. So if its lost then a full new rotor is required. In order to overcome this issue, I modelled new once.These have properties pretty close to the originals, please see pictures. However, they are not 100%. Its very difficult to measure the size of small details as well as keep the model rather easily printable.PrintingThe orientation of the stl model needs to be turned 180 degree before printing (bottom of the nozzle should be touching the build plate). The print will require support, touching buildplate. Best results achieved with normal support. I used Cure 5.4.Also the nozzle has small details that are necessary to be accurately printed so in order to have a very good result a low resolution is recommended (the lowest available, I used an Ender 3 and 0.08 mm layer height). Also I recommend 0.2 nozzle.If the print is not