Cults3D
Home
Zum Modell
Rainfall shower
0
Downloads
0
Likes
0
Makes
Rainfall shower for carbine 300X300mm mounting in two possible. Ours already had holes in the ceiling where the hose goes through.
The holes for water jets are 2.5mm and are well tested to provide a water-saving function without compromising on a good shower feeling.
Inside is a water sprayer that distributes the water over the entire shower head if you have the right pressure in the hose.
The hose needs to be similar to the one in the picture for it to fit. It is a 1/2 connection.
Setting in slicer:
Number of walls 6pcs
Upper shell layers 6pcs
Bottom shell layers 6pcs
Infill 5%
The holes for water jets are 2.5mm and are well tested to provide a water-saving function without compromising on a good shower feeling.
Inside is a water sprayer that distributes the water over the entire shower head if you have the right pressure in the hose.
The hose needs to be similar to the one in the picture for it to fit. It is a 1/2 connection.
Setting in slicer:
Number of walls 6pcs
Upper shell layers 6pcs
Bottom shell layers 6pcs
Infill 5%
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
