Raise3D Front Blower Fan Bracket

This is a remix of the fantastic bracket by Firesped and Anubis132. Unfortunately when printed on my Zortax the fan port was too large for the blower fans I was using so this is a simple remix making the fan duct entrance just 0.8mm narrow which provides a perfect fit for the fans I am using.

Attach using 2 x M3x16 bolts direct to the 2 small holes that sit directly between the hot end attchment bolts on the front of the extruder (these holes may be covered by the Cuation: Hot sticker). Then fit the fan to the bracket and attach using either 2 x M4 bolts direct to the holes in the bracket or 2 x M3 bolts and nyloc nuts. Plug cable into the second from front connect or on the breakout board (observe polarity as other fans - you may need to swap the pins in the small white fan connector). Then simply use your cslicer to control this fan as part of the slicer settings.