Thingiverse
Raise3D N2 Part Fan Bracket
by abedolinger
31
Downloads
18
Likes
0
Makes
Remix of Anubis123's remix of Firesped's blower fan duct. I made the following changes:
- Split into two parts to minimize supports
- Strengthened the fan mount arms
- Removed the wall of the duct on the nozzle side, so more air gets pushed there. I found that the last version wasn't as direct as I wanted
- Tailored the extruder mount to slip into the extruder's front bolts
Required parts:
50mmx15mm blower fan
4x M3x16mm bolts
2x M4x16mm bolts
Print with ABS or other temp-resistant material.
Thanks very much to the original creators, hope you can get some use out of this!
- Split into two parts to minimize supports
- Strengthened the fan mount arms
- Removed the wall of the duct on the nozzle side, so more air gets pushed there. I found that the last version wasn't as direct as I wanted
- Tailored the extruder mount to slip into the extruder's front bolts
Required parts:
50mmx15mm blower fan
4x M3x16mm bolts
2x M4x16mm bolts
Print with ABS or other temp-resistant material.
Thanks very much to the original creators, hope you can get some use out of this!
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
