Thingiverse
Raised and Tilted Camera Mount
2
Descargas
0
Likes
0
Makes
This is a raised and tilted camera mount I designed for our Bonoch baby camera.
Once the model printed, I laid a thin/medium layer of super glue gel (just what I had laying around) around the inner wall of the angled side of the stand. I then carefully put the threads of the screw through so the super glue made contact with the head of the screw and not the threads (this will allow me to unscrew the camera without loosing the screw inside the stand). I then Installed the camera to get the desired orientation and used super glue again to attach the stand to the shelf.
The screw I used was a 1/4"-20x3/4" Machine screw a Nut & Bolt Assortment kit I got from harbor freight.
Once the model printed, I laid a thin/medium layer of super glue gel (just what I had laying around) around the inner wall of the angled side of the stand. I then carefully put the threads of the screw through so the super glue made contact with the head of the screw and not the threads (this will allow me to unscrew the camera without loosing the screw inside the stand). I then Installed the camera to get the desired orientation and used super glue again to attach the stand to the shelf.
The screw I used was a 1/4"-20x3/4" Machine screw a Nut & Bolt Assortment kit I got from harbor freight.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
