Thingiverse
Rally obedience stand
door xkyklopx
0
Downloads
0
Likes
0
Makes
Based on work (https://www.thingiverse.com/thing:2227499)
redone from scratch. Dimensions for holder are now 224*25 mm, fits perfectly to ender hotbead. Like this it can take whole laminated A4 sheet without squeezing
Everything was designed for 0,8 mm nozzle, every wall should be 2,4 mm wide.
Print tested, and you will need cooling in places where are holes.
There is enough free space, so part just fall together, and you can secure it by piece of filament, set on fire and than squish by something flat.
redone from scratch. Dimensions for holder are now 224*25 mm, fits perfectly to ender hotbead. Like this it can take whole laminated A4 sheet without squeezing
Everything was designed for 0,8 mm nozzle, every wall should be 2,4 mm wide.
Print tested, and you will need cooling in places where are holes.
There is enough free space, so part just fall together, and you can secure it by piece of filament, set on fire and than squish by something flat.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!