RAMBO and Raspberry Pi Case

Updated:
V2 : Thinned out walls
Added logos to reduce plastic use. (10m total on mine for one half)
Fixed some bugs.
Added support in vents
Added wire channel in top for fans.

This is a case built to free my Mendel Max from cables. This case holds both the RAMBo control board and the Raspberry Pi to enable Wifi or Ethernet access to the printer and not have to be tethered to a PC.

Threaded for M5 bolts. Will need to either tap the RAMBo side of the case, or just let the bolts thread it the first time. Built for 2 40mm x 10mm fans. Should sit in there side by side and be snug without rattling.

This is my first design and I have not printed it yet as my printer is not done yet. Please be nice. I may have a friend print it on a uPrint and see how it turns out.

Future plans:
-Build internal wiring guides.
-Build mount points for the Mendel once I decide where it should be mounted. Should fit under the bed but will have to experiment and then add bolt moun