Thingiverse
Rambo Mount
von JacobF
1
Downloads
3
Likes
0
Makes
This is to mount a Rambo to the underside of my delta printer that is wood. M3 screws are used to fasten to piece and any generic screws that fit through the holes to mount to bottom.
I found that for some reason may be printer or measurements but if holes don't line up just rotate the piece until it fits.
I found that for some reason may be printer or measurements but if holes don't line up just rotate the piece until it fits.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
